Secabo C40 Betriebsanleitung PDF herunterladen (Seite 9)

• After installing, connect the vinyl cutter to the USB interface on your PC using

the USB cable provided. Windows then indicates that new hardware

components have been recognized and shows when the installation is

completed.

• To determine the number assigned to the new interface, it is necessary to call

the Windows Device Manager. For this purpose, click on Workplace with the

right mouse key and select Properties. Then select the Hardware tab in the

window which opens and click Device Manger. The serial and parallel

interfaces on the computer are listed under the point Connections, including

the USB To Serial connection. The interface number (e.g. COM1) indicated

following the connection is the connection number to be used (e.g. in Artcut).

• If it is necessary to change the connection number, proceed as follows: Click

the connection with the right mouse key and select Properties.

• Then click Advanced on the Connection Settings tab and enter the new

number in the COM connection number field. This is required, for example,

when using cutting programs such as Artcut, because Artcut can control vinyl

cutters only over the COM1 or COM2 interface.

5.3 Connection via Serial Interface

No special installation is required when you connect your Secabo vinyl cutter to the

hardware-side serial interface on your PC; it is only necessary to connect the plotter

to the interface using the cable provided.

5.3.1 Be sure to check

Be sure to check the following settings before starting the first time:

• Open the FlexiStarter cutting software.

• Create your inscription or graphic and click Cut/plot file. In order to use Date

from CorelDraw, the graphic must be exported from CorelDraw as EPS and

can be opened in FlexiStarter via File / Open.

• Select your Secabo vinyl cutter (C30III, C60III or C120III).

• In the Production Manager go to Settings / Job standard settings / cutting

options, knife offset and enter a value between 0,020cm and 0,033cm.

• Activate the overcut option with a value of 0,0254cm in the File - Cut/Plot -

Advanced menu. If your vinyl cutter is controlled directly, please select local

PC.

• Set the flow control to Xon/Xoff in the properties and set the baud rate to

38400. Set the baud rate both in the software and in the machine‘s menu. In

version 8.5, you can select the baud rate and flow control in the production

manager by clicking the knife symbol in the left area of the window.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Keine Kommentare

Secabo C40 Betriebsanleitung Seite 9